The production purpose of catalytic combustion equipment is for environmental protection and the treatment of industrial waste gas pollution. In industrial production, a large amount of exhaust gases containing benzene, alcohols, ketones, and other pollutants are emitted. Harm the health of workers and pollute the environment. Catalytic combustion equipment, as a means of controlling exhaust gas pollution, has achieved significant results in China. However, there are still some potential uncertainties and accident hazards in the design, processing, and application of catalytic combustion devices, which can lead to fire and explosion in severe cases. Therefore, it is necessary to establish unified standards or design specifications for concentration control of catalytic combustion treatment waste gas. In addition to the above factors, from a technical perspective, the following non factors are also worth noting:

一、氣體的爆炸下限與溫度有關。通常，溫度愈高，反應速度愈快，爆炸范圍愈大。當進入催化燃燒裝置的廢氣濃度過大時，催化燃燒裝置的溫度將會升高，加之自前國產催化燃燒裝置均未設置廢氣濃度檢測和控制設備，而溫度升高后的廢氣的爆炸下限值將比手冊給出的值要小，再加上裝置中廢氣成分混合的不均勻性，在局部區域可能超過高溫條件下廢氣的真實爆炸下限，則有爆炸的危險。

1、 The lower explosive limit of a gas is related to temperature. Usually, the higher the temperature, the faster the reaction speed, and the larger the explosion range. When the concentration of exhaust gas entering the catalytic combustion device is too high, the temperature of the catalytic combustion device will increase. In addition, since the previous domestic catalytic combustion devices have not been equipped with exhaust gas concentration detection and control equipment, the lower explosion limit of the exhaust gas after temperature increase will be smaller than the value given in the manual. In addition, the uneven mixing of exhaust gas components in the device may exceed the true explosion limit of the exhaust gas under high temperature conditions in local areas, There is a risk of explosion.

二、一般來講，大多數廢氣中的成份在同樣爆炸下限濃度下，所含的燃燒熱值可視為相同值，每1%的爆炸下限值約含熱值1868千焦/牛·米勺如果燃燒，即熱值全部用于使廢氣本身升溫，則1%的爆炸下限值的廢氣燃燒可使廢氣升溫15.3℃；當廢氣濃度達到25%的爆炸下限值時，可使廢氣本身溫度升高。

2、 Generally speaking, most components in exhaust gas can be considered to have the same combustion heat value at the same lower explosive limit concentration. For every 1% lower explosive limit, the combustion heat value is approximately 1868 kJ/N · m spoon. If combustion occurs, that is, all the heat value is used to raise the temperature of the exhaust gas itself, then the combustion of 1% lower explosive limit exhaust gas can raise the temperature of the exhaust gas by 15.3 ℃; When the concentration of exhaust gas reaches the lower explosive limit of 25%, it can cause the temperature of the exhaust gas itself to increase.

在使用催化燃燒設備時要注意問題。按照規定進行操作，以免發生意外。

Pay attention to issues when using catalytic combustion equipment. Operate according to regulations to avoid accidents.

本文由沸石轉輪＋RTO友情奉獻.更多有關的知識請點擊: http://www.shtzxx.cn真誠的態度.為您提供為全面的服務.更多有關的知識我們將會陸續向大家奉獻.敬請期待.

This article is dedicated by Zeolite Wheel+RTO Friendship. For more information, please click on: http://www.shtzxx.cn Sincere attitude. We will provide you with comprehensive services. We will gradually contribute more relevant knowledge to everyone. Stay tuned