一、系統概述

　　1、 System Overview

　　RTO蓄熱式焚燒爐廢氣凈化系統，又稱蓄熱式熱氧化爐，是一種熱能轉換設備。它利用陶瓷蓄熱體作為熱能儲存和交換的媒介，通過蓄熱和放熱過程，實現有機廢氣的熱氧化分解。

　　RTO regenerative incinerator exhaust gas purification system, also known as regenerative thermal oxidation furnace, is a type of thermal energy conversion equipment. It uses ceramic heat storage as a medium for thermal energy storage and exchange, achieving thermal oxidation and decomposition of organic waste gas through heat storage and release processes.

　　二、工作原理

　　2、 Working principle

　　RTO蓄熱式焚燒爐廢氣凈化系統的工作原理如下：

　　The working principle of the RTO regenerative incinerator exhaust gas purification system is as follows:

　　廢氣通過引風機進入蓄熱室1進行預熱，利用陶瓷蓄熱體回收的熱量，使廢氣溫度升高至接近熱氧化溫度。

　　The exhaust gas enters the heat storage chamber 1 through the induced draft fan for preheating, and the heat recovered by the ceramic heat storage body is used to raise the exhaust gas temperature to near the thermal oxidation temperature.

　　預熱后的廢氣進入燃燒室進行熱氧化，使有機廢氣中的VOC氧化分解成二氧化碳和水。這一過程中，燃燒器燃燒補充熱量，使廢氣升至設定的氧化溫度（通常為730~780℃）。

　　The preheated exhaust gas enters the combustion chamber for thermal oxidation, which oxidizes and decomposes the VOCs in the organic exhaust gas into carbon dioxide and water. During this process, the burner burns to supplement heat and raise the exhaust gas to the set oxidation temperature (usually 730-780 ℃).

　　氧化后的高溫氣體經過另一蓄熱室2進行熱量交換，溫度降低后排放至大氣。與此同時，蓄熱室2的蓄熱體吸熱，為下一個循環加熱新輸入的低溫廢氣做準備。

　　The high-temperature gas after oxidation undergoes heat exchange in another heat storage chamber 2, and is discharged into the atmosphere after the temperature is reduced. At the same time, the heat storage body of heat storage chamber 2 absorbs heat, preparing for the next cycle to heat the newly input low-temperature exhaust gas.

　　引入部分凈化后的氣體對蓄熱室3進行吹掃，清除可能殘留的有機物質，為下一輪熱交換做準備。

　　Introduce partially purified gas to blow the heat storage chamber 3, removing any residual organic substances and preparing for the next round of heat exchange.

　　整個過程中，蓄熱室通過切換閥或旋轉裝置進行切換，分別進行吸熱和放熱，實現連續工作。

　　Throughout the entire process, the heat storage chamber is switched by switching valves or rotating devices to absorb and release heat respectively, achieving continuous operation.

　　三、系統特點

　　3、 System features

　　節能性：采用蓄熱體回收熱量，降低能源消耗，提高熱能利用率。

　　Energy saving: Adopting thermal storage to recover heat, reducing energy consumption, and improving thermal energy utilization efficiency.

　　適應性：適應大風量、低濃度的有機廢氣處理，以及廢氣中VOC組成和濃度的變化、波動。

　　Adaptability: Adapt to the treatment of high air volume, low concentration organic waste gas, as well as changes and fluctuations in VOC composition and concentration in the waste gas.

　　安全性：維護工作量少，操作安全可靠，具有多種安全保護措施。

　　Security: Low maintenance workload, safe and reliable operation, with multiple security protection measures.

　　穩定性：RTO系統運行穩定，能長時間保持有效的處理效果。

　　Stability: The RTO system runs stably and can maintain effective processing effects for a long time.

　　四、應用領域

　　4、 Application Fields

　　RTO蓄熱式焚燒爐廢氣凈化系統廣泛應用于石油及化工（如塑料、橡膠、合成纖維、有機化工）、油漆生產及噴漆、印刷（包括印鐵、印紙、印塑料）、電子元件及電線、及染料、醫藥、顯像管、膠片、磁帶等行業。這些行業產生的廢氣經過RTO系統處理后，可達到廢氣綜合排放標準，直接排放至大氣中。

　　The RTO regenerative incinerator exhaust gas purification system is widely used in industries such as petroleum and chemical (such as plastics, rubber, synthetic fibers, organic chemicals), paint production and spraying, printing (including printing iron, printing paper, printing plastics), electronic components and wires, as well as dyes, pharmaceuticals, cathode ray tubes, films, tapes, etc. After being treated by the RTO system, the exhaust gases generated by these industries can meet the comprehensive emission standards and be directly discharged into the atmosphere.

　　五、維護與保養

　　5、 Maintenance and upkeep

　　為確保RTO蓄熱式焚燒爐廢氣凈化系統的正常運行和延長使用壽命，應進行以下維護和保養工作：

　　To ensure the normal operation and prolong the service life of the RTO regenerative incinerator exhaust gas purification system, the following maintenance and upkeep work should be carried out:

　　定期檢查和更換媒介層：RTO設備中的熱交換媒介層是關鍵部件之一，需要定期檢查其狀態，并根據實際情況及時更換。

　　Regular inspection and replacement of media layer: The heat exchange media layer in RTO equipment is one of the key components, and its status needs to be checked regularly and replaced in a timely manner according to the actual situation.

　　檢查火焰控制系統：火焰控制系統非常重要，需要定期檢查其工作狀態和靈敏度，確保能夠快速響應和控制火焰。

　　Checking the flame control system: The flame control system is very important and needs to be regularly checked for its working status and sensitivity to ensure rapid response and control of the flame.

　　清潔和更換過濾器：過濾器可以地去除廢氣中的顆粒物和污染物，需要定期清潔或更換，以保證其過濾效果。

　　Cleaning and replacing filters: Filters can effectively remove particulate matter and pollutants from exhaust gas, and require regular cleaning or replacement to ensure their filtering effectiveness.

　　檢查電機和傳動系統：定期檢查電機和傳動系統的工作狀態和潤滑情況，確保正常運轉。

　　Check the motor and transmission system: Regularly inspect the working condition and lubrication of the motor and transmission system to ensure normal operation.

　　管道和閥門維護：定期維護管道和閥門，包括清理、潤滑和更換損壞部件等工作，確保設備的密封性和流量控制精度。

　　Pipeline and valve maintenance: Regular maintenance of pipelines and valves, including cleaning, lubrication, and replacement of damaged parts, to ensure the sealing and flow control accuracy of the equipment.

　　本文來自：沸石轉輪＋RTO 更多的內容請點擊：http://www.shtzxx.cn我們將會為您提問的問題提供一個滿意的服務，歡迎您的來電！

　　This article is from: Zeolite Wheel+RTO. For more content, please click: http://www.shtzxx.cn We will provide satisfactory service for the questions you ask. Welcome to call us!